24/7 emergency

888-334-BBMS (2267)
An open rooftop unit control cabinet with relays, wiring and terminal blocks

HVAC and refrigeration controls service

We set up and service the controls that run commercial heating, cooling and refrigeration systems for businesses in Massachusetts (except Cape Cod), New Hampshire and Rhode Island.
Equipment down? Call us 24/7
A BBMS technician works on the terminals of a control cabinet full of fuses and wiring

What HVAC controls do

HVAC controls are the hardware and software that monitor, regulate and automate heating, ventilation and air-conditioning equipment to maintain comfort, air quality and energy efficiency.

Our President, Jeffrey P Mitza, is an HVAC mechanical technical service and controls specialist.

How an HVAC control system works

Four parts, so you can name where a problem sits.

Interface

User interface

Where schedules and setpoints are seen and changed.

Schedules and setpoints

Logic

Controller

Runs the programmed logic that decides what equipment should do.

Outputs

Controlled devices

Dampers, valves and the equipment itself.

The building responds

Inputs

Sensors

Read temperature, humidity and other conditions.

Why is the building too hot or too cold when the setpoint looks right?

Often the equipment is fine and the controls are telling it the wrong thing.

A BBMS technician kneels at a rooftop unit's open electrical cabinet and reads a multimeter
  • Overrides left in place

    Manual changes to setpoints and schedules keep equipment running longer and harder than needed.

  • Running when closed

    “If you do not need it, turn it off.” Schedules should match the hours you are open.

  • Sensors and dampers

    Fault alarms and trended data show whether dampers, sensors and economizers work correctly.

  • Economizers

    Humidity sensors need regular calibration, and outdoor-air dampers should close fully when off.

What can re-tuning existing controls do?

5 to 25 percent

Typical building energy savings from re-tuning measures combined

Re-tuning uses data from the building automation system to find operational problems. That is a published range for buildings in general, not a figure for yours. It pairs well with preventive maintenance.

Can you service controls another contractor installed?

Systems that communicate over standard, open protocols like BACnet can work with existing equipment from other manufacturers.

Tell us the make and model of your controls when you request service, and we will confirm before the visit.

HVAC controls questions

Can equipment be off when we are closed?

That is what schedules are for. Equipment should run when you need it and be off when you do not, and manual overrides left in place are a common reason it keeps running.

Do you work on refrigeration controls too?

Yes. We set up and service the controls that run heating, cooling and refrigeration equipment, including walk-in coolers and freezers.

Can you also repair the equipment the controls run?

Yes. We repair, install and maintain rooftop units, boilers, furnaces, heat pumps and walk-ins, so one visit can cover both the control fault and the equipment.

Is a controls fault an emergency?

If it stops heating, cooling or refrigeration, call us 24/7. Otherwise, request service during office hours, Monday to Friday, 8:00 AM to 4:30 PM Eastern.

Get your controls checked

Request service with the symptom you are seeing and the make of your controls. If equipment is down now, call us 24/7.

B&B Mechanical Services uses cookies for analytics and advertising, to improve this site and measure our ads. See our cookie policy.